Then select all the polylines/groups which represent the contour lines at the same level and click on the ArchiTerra Contour Lines tool: the dialog window appears and here you can insert their level value.ĪrchiTerra will collect all the needed info from the selection and will substitute it with a set of hotspot (“special” hotspots that store the level info) and segments (special lines that represent the constraints between each couple of consecutive nodes). You can also use the spline tool but, in this case, please pay attention to your magic wand settings because ArchiTerra will follow these settings in order to transform these entities. Ok, let me try to give you some suggestion.Ĭontour line issue: draw your contour lines by using the ArchiCAD polyline tool or a set of connected and grouped lines, arcs. This is due to a lot of causes but I'm not here to "justify" our job but to provide you with our best help.īTW, if anybody needs help on our add-on can directly contact me by using my e-mail address or phoning at Cigraph. and I don't agree because I'm the first one!) probably is right: our documentation sometime (or maybe often) isn't enough clear ! Unfortunately one of the good friend of mine (someone who loves to define himself like the funniest architect in the world.
0 Comments
Leave a Reply. |